How to Order a Stinger By AXE Trailer Lift

© 2011 Stinger by Axe Equipment. All Rights Reserved.

The Model Number of our Trailer Lift, represents the length (in inches) and style of ramps, which is, Formed Ramps

(One Piece Diamond Plate), Channel Ramps (Diamond Plate Covered), or Open Channel Ramps (Dealer Supplied Floor)

The second set of variable numbers needed to complete the order represents the desired overall width of the lift in inches.  (Example: 95.5") When ordering the width of your lift, leave a minimum ¼” clearance (1/2” total) from each side of the interior walls.  For example, if your 96” interior trailer walls are square from top to bottom you could order a 95.5” wide lift for a nice fit.

For example, if you ordered a  Model # T156FG3-95.5 Trailer Lift, you would receive: (T) Trailer Lift 156” long powder coated (F) Formed Ramps (G3) Generation 3 and a width of 95.5”. 

The remainder of the lift would be completed using the Standard Trailer Equipment List shown below:

• 83” Lift Height-79” Under Ramp
  

• 94” Columns
  

• Gloss White Powder Coated Finish
  

• Single Point Lock Release Lever
  

• Polished Aluminum Bolt-On Tire Stops
  

• 39” Polished Aluminum Light Weight Drive On Ramps
  

• 12 Volt Power Supply with Hand Held Remote
  

• Hydraulic Fluid
  

• 4000 lbs Capacity
  

• 5 Year Structural Warranty
  

• 2 Year Mechanical Warranty
  

Unit is complete and ready for installation. 

A Hole Location Diagram which shows you where to mount your stiffeners inside the walls and floor of your trailer is available for our Standard Stinger by AXE Trailer Lifts.