Generation 3 Trailer Lift Standard Features
© 2011 Stinger by Axe Equipment. All Rights Reserved.
All Stinger by AXE lifts are designed with a single lock release handle that can be located on any corner of the lift.
The lift shown above is lifted to the 72" lock height, allowing you ample room underneath the lift. At the full 79" lock height you are able to walk under the lift.
Pre-set Locks give the following distance under the ramp:
48", 54", 60" ,66", 72", and 79"
Under Ramp Clearance.
(Custom Lock Heights are Available)
Hidden Lock Release Linkage and Inside Post Locks and Lock Blocks.
The Hidden Lock Release Linkage reduces installation time for the lift installer.
Each Column is built with a tie down point on the foot and the crossbar. This feature allows you to anchor the ramps, eliminating the movement as you travel.
(straps not included)
Cross Bar Tie-Downs and 3 Vehicle Tie Down Points on Each Ramp
Stinger by AXE provides 3 tie down points built on each ramp. A tie down point is located on the front, middle, and rear of the ramp, allowing you to tie down whatever you may be hauling during transit.
A 12 volt power unit with hand held remote is standard on all Stinger by AXE Trailer Lifts. The power unit has a plastic tank and a 2 gallon oil reservoir. It can be mounted Vertically or horizontally inside the trailer. The hand held remote has an 8' cord allowing you to easily maneuver around the lift.
Our 39” polished aluminum drive on ramps are another great standard feature. Low clearance vehicles can park safely without any drag on spoilers or front end components.
One Pair Removable Polished Aluminum Drive on Ramps
Pulleys with Bearings Installed on all Stinger by AXE Lifts
12 Volt Power Unit with Hand Held Remote
5 Year Structual Warranty
2 Year Mechanical Warranty
4,000 lb Capacity
Lift shown above has optional black powder coating.